When it comes to backup cameras, there are two common question that most people have: where to mount backup camera and how do I install them into my car? Most people think that is extremely difficult to install backup cameras. So it has become a standard feature on vehicles. In May of 2018, the National Highway Traffic Safety Administration announced that it would require all vehicles sold in the United States to include backup cameras. It can reduce your blind spots and make your driving more enjoyable. And one of the green wires is solid green, the other has a white stripe.Īnd yes I have a multimeter but it’s not with me at the moment.If you own a car, you may know about the backup camera. The other white has faint gray printing I can’t read. One of the white wires has dark printing on it that states “low voltage”, so I would think that’s the 12v hot. I tried pigtailing the red/brown fixture wires to the two white trailer wires, and the black fixture wire to the two green trailer wires (to simulate the set up of the original fixture wiring), but the fixture doesn’t power up when I turn on my truck lights.ĭoes anyone have a wiring diagram for this model trailer that identifies the four wires or can otherwise help me identify them? I’ve attached a pic for reference. Yellow is the trigger signal (used only if you want the camera to fire up only when the turn signal is activated, which I don’t). Red and brown are the hot wires for the camera and marker light. The new fixture with camera has four wires: red, brown, yellow, and black. The black fixture wire was pigtailed to the two green trailer wires. The white fixture wire was pigtailed with the two white trailer wires. The trailer has four wires, two white and two green. The factory side marker fixture has two wires, one white and one black. FYI, the trailer lights all power up perfectly when I turn on my truck lights.

None of the instructions or diagrams I can find online address this particular trailer and light combo.

I have a 2021 2600RB, and pulled off the factory side front marker light so I can install the Furrion side marker light with camera. I dont typically have help backing up so these made it a ton easier backing into a tight spot. I did put the cameras on the front marker lights and the cameras work very well. I mounted them as replacements for the marker lights in the lower middle of the trailer. I've resolved to try that some time when sufficient ambition for doing the swap has gathered in my bones.īrian, I have the side cameras. I've surmised that the *very* brief hesitations seen from time to time are a result of them not having a 'real' antenna and therefore not having as strong a radio connection to the monitor in the truck.Īt least one other person here has mounted these cameras in the front marker light position, up near the nose of the trailer, and reported being very pleased with image quality and stability. The cameras don't provide quite as good an image as the rear camera does very serviceable and useful, but not as smooth and bright.

Has anyone used these successfully on the their GD trailer. I have read that some have had issues with the power at the side market lights not powering the cameras (not GD but just in general). I am wanting to add the side cameras for the Furrion system.

Furrion side camera installation